Navigation:Inplot <Root level>

Configure: Time

Send comments on this topic.

 

Configure: Time

These items will be used in calculating the running time of the program.

 

Rapid Feedrate – Used for calculating time for rapid moves. Inches per minute or MM per minute, according to maching.

 

Deceleration Factor – Compensation for the deceleration and acceleration according to the feed rate. Usually a very small number.

 

Numeric Values – Need to check Inch or Metric for an accurate Lathe time calculation.

 

Add Time – When Inplot finds the String, it will add the listed amount of Time to the running time(in minutes).

See Also: Time. 

 

_________________________________________________________________


Copyright © 2020 i-Logic Software