Comment Code: TOF

Comment Code TOF

This Code will set X,Y and Z offset values when found during plotting. When the offsets are set with a value, all plotting after that will offset by that amount in that axis. This is useful for plotting programs that have coordinates that have been adjusted for tool set lengths etc. Just use this comment code with the compensating amount in the axis value and the plotting will appear on the part geometry where it should. Ex. (TOF X2.0Y1.0Z0)

The Offsets checkbox must checked in Configuration Plotting to enable this function.

You would have to use (TOF X0Y0Z0) in the program to change the offsets back to 0. Also, pressing plot Reset button sets the offsets back to 0.